Roland V-Drums TD-20X - Page 51

51
Chapter 2. Instrument Settings [INST]
CRASH/SPLASH/CHINA/STACKED CYMBAL/RIDE
fig.02-023-cym-f1.eps_70
Instruments for which V-EDIT is not available
Electronic instruments (Dynamic Pitch Bend)
“Dynamic Pitch Bend” is a function that you can use with the
electronic instruments that were added on the TDW-20.
You can make the following settings when you’ve selected
the “SNARE ELEC,” KICK ELEC,” or “TOM ELEC” instrument
from the “EXP” instrument group.
If “Dynamic Pitch Bend” is on, you’ll be able to change the
pitch by varying the force (velocity) with which you strike the
pad.
fig.02-027-dynapitch.eps_70
Depending on the “Basic Pitch” setting of the
instrument, there may be cases in which raising (or
lowering) a value does not produce further change.
Other instruments
fig.02-028-decay.eps_70
Parameter
Value Description
[F1 (SIZE)] button
Size
1”–40”
Cymbal diameter
[F2 (SIZZLE)] button
Sizzle Type
OFF, RIVET,
CHAIN, BEADS
Type of sizzle
Sizzle Amount -3–+3
Amount of sizzle
[F3 (SUSTAIN)] button
Sustain
-31–+31
Length of sustain
[F4 (MIC)] button
Mic Position
OUTSIDE2–1,
STANDARD,
INSIDE1–2
Tonal change caused by
microphone position
Parameter
Value Description
[F1 (PITCH)] button
Basic Pitch
-480 – +480
Pitch
Dynamic Bend OFF, ON
Turns dynamic pitch bend
on/off
Bend Depth -24 – +24
Amount of pitch change
controlled by velocity
Bend Time -31 – +31
Time over which currently
controlled pitch change
will occur
[F2 (DECAY)] button
Decay Time
-31 – +31
Length of the decay
Parameter Value Description
Pitch
-480–+480
Pitch
Decay Time -31–+31
Duration of the sound
(decay time)
TD-20X_e.book 51 ページ ２００９年６月８日 月曜日 午後３時５０分