EasyManua.ls Logo

Roland V-Drums TD-20X - Viewing the Output Level (OUPUT MONITOR) [F5 (MONITOR)]; Naming a Drum Kit [F3 (NAME)]; Playing Cross Stick [F5 (XSTICK)]

Roland V-Drums TD-20X
156 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
41
Chapter 1. Drum Kit Settings [KIT]
You can view the volume that is being output from the
MASTER OUT, PHONES, or DIRECT OUT jacks.
Use the [-] [+] buttons or the [VALUE] dial to choose the jacks.
fig.01-010-mon.eps_70
You can rename the currently selected kit; the maximum is 12
characters.
1.
Press the [KIT] button.
The “DRUM KIT” screen appears.
2.
Press the [F3 (NAME)] button.
The “DRUM KIT NAME” screen appears.
fig.01-011-name.eps_70
3.
Use the [CURSOR (left/right)] buttons to move the
cursor to the character to be changed.
4.
Use the [VALUE] dial, the [-] [+], or [CURSOR (up/
down)] buttons to change the character.
5.
Press the [EXIT] button to return to the previous
screen.
For each kit, you can specify whether cross-stick techniques
can be used.
1.
Press the [KIT] button.
The “DRUM KIT” screen appears.
2.
Press the [F5 (XSTICK)] button.
Each time you press the button, cross-stick will alternate
between enabled and disabled.
Cross stick can be played
fig.01-012-xstick-on.eps_70
Cross stick not possible
fig.01-013-xstick-off.eps_70
When using the cross-stick technique, you can specify
the velocity at which the cross-stick sound will be
switched with the open rim shot sound. If this “XStick
Thrshld” setting is set to “127,” only the cross-stick
sound will play every time. For more about making this
setting, refer to “Detailed Settings for Rim Shots [F2
(RIM)]” (p. 104).
Viewing the Output Level (OUPUT
MONITOR) [F5 (MONITOR)]
Naming a Drum Kit [F3 (NAME)]
Function button
[F1 (INSERT)]
A blank space is inserted at the cursor position,
and characters after this point are moved to the
right one space.
[F2 (DELETE)]
Character at the cursor position is deleted, and
characters after this point are moved to the left
one space.
[F3 (SPACE)]
Character at the cursor position is replaced by
a blank space.
[F4 (CHAR)]
Type of character at the cursor position
changes between uppercase/lowercase
alphabet, or numbers and symbols.
Playing Cross Stick [F5 (XSTICK)]
TD-20X_e.book 41 ページ 2009年6月8日 月曜日 午後3時50分

Table of Contents

Related product manuals