87
Chapter 6. Recording and Editing Patterns—Sequencer
This connects two patterns to create one pattern. The pattern
specified as “Dst” will be first, and the pattern specified as
“Src” will be connected to it. The new pattern will be created
in “Dst.”
fig.07-Apd1
1.
In the “PATTERN EDIT” screen (p. 85), press the [F2
(APPEND)] button.
“PATTERN APPEND” screen appears.
fig.06-12-ptn-append.eps_70
2.
Press the [CURSOR (up)] button to move the cursor
to “Src.”
3.
Using the [-] [+] buttons or the [VALUE] dial, select
the pattern that is to form the latter part of the
conjoined result.
4.
Press the [CURSOR (down)] button to move the
cursor to “Dst.”
5.
Using the [-] [+] buttons or the [VALUE] dial, select
the pattern that is to form the first part of the
conjoined result.
6.
Press the [F5 (APPEND)] button.
The confirmation screen appears.
fig.06-13-ptn-append-conf.eps_70
To cancel, press the [F1 (CANCEL)] button.
7.
Press the [F5 (EXECUTE)] button.
This erases the pattern. Performance data is erased, while
beat, measure length, and other settings are left intact.
fig.07-Ers1
You can erase portions of the pattern, in measure units. The
erased portions become blank measures.
fig.07-Ers2
Although the data is erased, the pattern length is
unchanged.
1.
In the “PATTERN EDIT” screen (p. 85), press the [F3
(ERASE)] button.
The “PATTERN ERASE” screen appears.
fig.06-14-ptn-erase.eps_70
2.
When you want to erase selected measures or part,
press the [F4 (MEASURE)] button.
The “PATTERN ERASE MEASURE” screen appears.
fig.06-15-ptn-erase-meas.eps_70
3.
Use the [CURSOR (left/right)] buttons to select the
parameter.
Connecting Two Patterns
[F2 (APPEND)]
Dst
+
12 43
Src
12 43
Dst
12 643785
Erasing a Pattern [F3 (ERASE)]
12 643785
12 643785
12 643785
12 643785
TD-20X_e.book 87 ページ ２００９年６月８日 月曜日 午後３時５０分
To Next Page
Loading...
