Roland V-Drums TD-20X - Hi-Hat Settings [F3 (HI-HAT)]

99
Chapter 8. Trigger Settings for Each Pad [TRIGGER]
1.
Press the [TRIGGER] button.
The [TRIGGER] button lights.
2.
Press the [F3 (HI-HAT)] button.
The [TRIGGER] button lights, and the “TRIGGER HIHAT” screen
will appear.
fig.08-003-hh.eps_70
3.
Use the [CURSOR (up/down)] buttons to select the
parameter.
The editable parameters will depend on the “Hi-Hat Type”
setting.
4.
Use the [-] [+] buttons or the [VALUE] dial to adjust
the setting.
5.
When you’re finished, press the [EXIT] button to
return to the “DRUM KIT” screen.
• Set the Hi-Hat Type to “VH12”
Adjusting the offset of VH-12 automatically
If you’re using the VH-12 V-hi-hat, execute the offset
automatically adjustment from the TD-20X after making
connections.
This adjustment is required in order to correctly detect open,
close, and pedal operations.
1.
In the “TRIGGER HI-HAT” screen, press the [F5
(OFFSET)] button.
The “VH OFFSET ADJUSTMENT” screen will appear.
fig.08-005-vh-offset.eps_70
2.
Loosen the clutch screw of the top hi-hat and let it
sit on the bottom hi-hat.
Do NOT touch the hi-hats or the pedal.
3.
Press the [F5 (EXECUTE)] button.
The [TRIGGER] button flashes, and the “VH Offset” parameter
is set automatically.
fig.08-006-vh-offset2.eps_70
When finished, the [TRIGGER] button stops flashing and
remains lit, and the following screen appears.
fig.08-007-vh-offset-comp.eps_70
You can also perform this operation by holding down
the [KIT] button and pressing the [TRIGGER] button (p.
25).
Hi-Hat Settings [F3 (HI-HAT)]
Parameter
Value Description
Hi-Hat
Type
Used Hi-Hat Controller
VH12 VH-12
VH11/FD VH-11, FD-8
Settings for the VH-12
Parameter
Value Description
Offset
-100– +100
Extent of Opening Hi-Hat
The bigger the value is, the
wider the opening extent is.
Foot Splash
Sens
-10– +10
(Initial Value: +5)
Amount of how easy to make
the Foot Splash
Noise
Cancel
1–3
(Initial Value: 1)
Amount of strength to cancel
the bow and edge noise when
you play “Foot Close.”
The bigger the value is, the
more difficult to have a noise
excluding the “Foot Close.”
CC
Resolution
NORMAL, HIGH
(Initial Value:
NORMAL)
Amount of Data Resolution
that is transmitted from Hi-Hat
Pedal.
When you control the pitch by
Hi-Hat Pedal (p. 52), the pitch
can be changed smoothly if
you set “High.”
Parameter
Value Description
TD-20X_e.book 99 ページ ２００９年６月８日 月曜日 午後３時５０分