Roland V-Drums TD-20X - Saving a Pattern [F5 (CARD)]; Saving a Pattern to a Compactflash Card [F1 (SAVE)]

89
Chapter 6. Recording and Editing Patterns—Sequencer
You can use an optional CompactFlash card to save pattern
data.
User patterns can be saved or loaded individually. This
provides a convenient way to handle just the patterns you
need.
fig.CardImage
When creating a backup on a CompactFlash card (p. 92),
user patterns are handled in sets of 100 patterns.
“PATTERN CARD” screen
fig.06-20-ptn-cd.eps_70
You can check the amount of CompactFlash card
available by pressing the [TOOLS] button (p. 125).
Patterns will be saved up to 100.
1.
Insert a CompactFlash card into the CompactFlash
card slot on the TD-20X’s front panel.
2.
Press the [PATTERN] button.
3.
Press the [F4 (EDIT)] button.
The “PATTERN EDIT” screen appears.
4.
Press the [F5 (CARD)] button.
The CompactFlash indicator light, and the “PATTERN CARD”
screen appears.
If you insert a card being used for the first time by the
TD-20X, display shows “Unformatted!” Refer to
“Formatting a CompactFlash Card [F1 (FORMAT)]” (p. 94)
and initialize it.
5.
Press the [F1 (SAVE)] button.
The “PATTERN SAVE” screen appears.
fig.06-21-ptn-cd-save.eps_70
6. Press the [CURSOR (up)] button, and then use the
[-] [+] buttons or the [VALUE] dial to select the
pattern you want to save.
7.
Press the [CURSOR (down)] button, and then use
the [-] [+] buttons or the [VALUE] dial to select a
backup pattern to which you want to save the
pattern.
You can select an empty backup pattern with the lowest
number by pressing the [F4 (NEW)] button.
8.
Press the [F5 (SAVE)] button.
The confirmation screen appears.
fig.06-22-ptn-cd-save-conf.eps_70
To cancel, press the [F1 (CANCEL)] button.
9.
Press the [F5 (EXECUTE)] button to save the
pattern.
Saving a Pattern [F5 (CARD)]
CompactFlash
Backup 99
Backup 01
Pattern (100)
Pattern 100
Pattern 001
• Never remove a CompactFlash card while the
CompactFlash indicator on the TD-20X’s top panel
is lit. Doing so may corrupt the unit’s data or the
data on the CompactFlash card.
• Carefully insert the CompactFlash card all the way
in—until it is firmly in place.
• The TD-20X can use CompactFlash cards rated for
3.3V in a capacity range of 16 MB–4 GB (type 1).
Other cards cannot be used.
Saving a Pattern to a CompactFlash
Card [F1 (SAVE)]
TD-20X_e.book 89 ページ ２００９年６月８日 月曜日 午後３時５０分