Roland V-Drums TD-20X - Copying a Drum Kit

42
Chapter 1. Drum Kit Settings [KIT]
You can copy a drum kit from preset memory or from a
CompactFlash card.
For user memory, you can rearrange the data by exchanging
the copy-source and copy-destination drum kits.
Be aware that when you execute the copy, the contents
of the copy-destination will be overwritten.
1.
Press the [COPY] button.
The [COPY] button will light, and the “COPY A” screen will
appear.
If a CompactFlash card (p. 91) is inserted in the CompactFlash
card slot, the CompactFlash indicator will also light.
fig.01-014-copy-a.eps_70
2. Press the [F1 (KIT)] button to select the drum kit.
fig.01-015-copy1-user.eps_70
The screen above can be accessed from the “DRUM KIT”
screen (p. 39) by pressing the [COPY] button while you
hold down the [SHIFT] button.
3.
Use the [F1]–[F3] buttons to select the copy-source.
4.
Use the [CURSOR] buttons, [-] [+] buttons, and
[VALUE] dial to specify the copy-source and copy-
destination.
If you selected [F2 (PRESET)] in step 3, specify whether you’re
copying from TD-20 or from TDW-20.
If you selected [F3 (CARD)] in step 3, select the copy-source
backup number.
5. Press the [F4 (EXCHNG)] or [F5 (COPY)] button.
If you selected [F1 (USER)] in step 3, you can exchange the
copy-source and copy-destination by pressing the [F4
(EXCHNG)] button.
Press the [F5 (COPY)] button to execute the copy.
A confirmation message will appear.
(Example: Copying a user memory drum kit)
fig.01-016-copy-conf.eps_70
If you decide to cancel the copy or exchange, press the [F1
(CANCEL)] button.
6.
Press the [F5 (EXECUTE)] button to execute.
You can copy fifty drum kits in a single operation.
Proceed as described in “Copying a drum kit,” but change
steps 2 as follows.
In step 2 , choose [F4 (50 KITS)].
Copying a Drum Kit
Function button
[F1 (USER)]
Copy from user memory.
Exchanging the copy-source and copy-
destination is possible only if the copy-source
is user memory.
[F2 (PRESET)]
Copy from preset memory.
You can choose from TDW-20’s preset data or
TD-20 preset data. Select this if you want to
return to the factory-set kit settings.
[F3 (CARD)]
Copy from backup data saved on a
CompactFlash card.
Copy source
Copy destination
Copying Fifty Drum Kits at a Time
TD-20X_e.book 42 ページ ２００９年６月８日 月曜日 午後３時５０分