Roland V-Drums TD-20X - Copying a Pattern [F1 (COPY)]

86
Chapter 6. Recording and Editing Patterns—Sequencer
Copy the pattern as is to the user patterns.
fig.07-Cpy1
You can copy selected measures of a part or pattern. Unlike
copying an entire pattern, settings such as instrument and
part volume etc. will not be copied.
fig.07-Cpy2
1.
In the “PATTERN EDIT” screen, press the [F1
(COPY)] button.
The “PATTERN COPY” screen appears.
fig.06-009-ptn-copy.eps_70
2.
When you want to copy selected measures or part,
press the [F4 (MEASURE)] button.
The “PATTERN COPY MEASURE” screen appears.
fig.06-010-ptn-copy-meas.eps_70
3.
Use the [CURSOR] buttons to select the parameter.
4.
Use the [-] [+] buttons or the [VALUE] dial to select
the pattern, part, and measures.
5.
Press the [F5 (COPY)] button.
The confirmation screen appears.
fig.06-011-ptn-copy-conf.eps_70
To cancel, press the [F1 (CANCEL)] button.
6.
Press the [F5 (EXECUTE)] button.
• If the number of measures in the copy-source pattern
and the copy-destination pattern differ, the number of
measures in the copy-destination pattern may increase
or decrease according to this difference.
• When “ALL” is specified in “Src part,” then only “ALL”
may be specified in “Dst Part.” Additionally, if other than
“ALL” is specified in “Src part,” then “ALL” cannot be
specified in “Dst Part.”
• When copying between drum kit parts and percussion
parts or backing parts, copy takes place in accord with
the predetermined correspondence between note
numbers and trigger inputs. Only note numbers
assigned to trigger inputs will be copied.
For more on note numbers and trigger inputs, refer to
“Note Number (Factory Settings)” (p. 137).
Copying a Pattern [F1 (COPY)]
Pattern
Part Measure
Src
Copy-source
pattern
Copy-source
part
Measures to be copied
(First Measure–Last
Measure)
Dst
Copy-
destination
pattern
Copy-
destination
part
First measure of the
copy-destination
Src
12 643785
Dst
12 643785
Src
12 643785
Dst
12 643785
TD-20X_e.book 86 ページ ２００９年６月８日 月曜日 午後３時５０分