5
Reference Manual
00809-0100-4803, Rev GA
Configuration
September 2017
Configuration
The Rosemount 3051SMV Engineering Assistant software is required to complete the flow
configuration.
2.3.2 Installation and initial setup
The following are the minimum system requirements to install the Rosemount 3051SMV Engineering
Assistant software:
Pentium-grade Processor: 500 MHz or faster
Operating system: Windows
™
Professional 7, 8.1, 10
– 32-bit
– 64-bit
256 MB RAM
100 MB free hard disk space
RS232 serial port or USB port (for use with HART
®
modem)
CD-ROM
Installing the Rosemount 3051SMV Engineering Assistant version 6.3
or later
Engineering Assistant is available with or without the HART modem and connecting cables. The
complete Engineering Assistant package contains the software CD and one HART modem with cables
for connecting the computer to the Rosemount 3051SMV (See “Ordering information” on page 138.)
1. Uninstall any existing versions of Engineering Assistant 6 currently installed on the PC.
2. Insert the new Engineering Assistant disk into the CD-ROM.
3. Windows should detect the presence of a CD and start the installation program. Follow the on-screen
prompts to finish the installation. If Windows does not detect the CD, use Windows Explorer or My
Computer to view the contents of the CD-ROM, and then double select the SETUP.EXE program.
4. A series of screens (Installation Wizard) will appear and assist in the installation process. Follow the
on-screen prompts. It is recommended the default installation settings are used.
Note
Engineering Assistant version 6.3 or later requires the use of Microsoft
®
.NET Framework version 4.0 or
later. If .NET version 4.0 is not currently installed, the software will be automatically installed during the
Engineering Assistant installation. Microsoft .NET version 4.0 requires an additional 200 MB of disk
space.
To Next Page
Loading...
