25
Reference Manual
00809-0100-4803, Rev GA
Configuration
September 2017
Configuration
Figure 2-18. Basic Setup Tab
Verify the Device Tag information. The tag information is used to identify specific transmitters on the
4–20 mA loop. This tag information may be edited.
Under the Flow Rate heading (fully compensated mass and energy flow feature board only), the type of
flow calculation (mass or volumetric) is displayed by the indicators on the right side of the box. The
Flow Calculation Type may be edited by selecting the Configure Flow Calculation Type button. The
Damping and Units of the Flow Rate may also be edited under this heading.
Note
The flow calculation within the device uses undamped process variables. Flow rate damping is set
independently of measured process variables.
To Next Page
Loading...
