Sam4s SPS-320 - Page 180

176 • Program Mode Programming Sam4s SPS-300 OP Manual v1.35
Option Entry Description
STOP OPERATIONS
WHEN E.J. IS FULL
Y or N If the electronic journal is enabled above, select Y if
you wish to stop operations when the journal memory
is full.
SEND ONLY NEGATIVE
ENTRIES TO E.J.
Y or N If the electronic journal is enabled above, select Y if
you wish to capture only transactions with negative
entries.
X REPORT &
DECLARATION TO E.J
Y or N If the electronic journal is enabled above, select Y if
you wish to capture reset reports.
DIRECT MULT MORE
THAN ONE DIGIT
Y or N If you allow direct multiplication of a preset PLU, you
can allow only single digit multiplication or
multiplication by more than one digit.
TENDER VALIDATION
Y:AMT TENDERED
N:AMT OF SALE
Y or N Validation is allowed if an appropriate optional printer
is connected to an RS-232C port. Here you can choose
the content of single line validation
EUROPEAN ROUNDING Y or N Select Y to implement the rounding system that you
enter on this page. For example, enter a range such as
“.00 - .05” and then select the rounding value for the
range.
DISABLE NOT FOUND
PLU
Y or N Select N to allow the operator to enter PLU prices and
other data when the entered PLU number is not found
in the PLU file.
EMBEDED PRICE BAR
CODE TYPE 1/3/4/7
1, 3, 4 or 7 Enables price embedded bar codes:
1 = Type 1 embedded barcodes have 5 item codes with
a price check sum and a 4 digit price field.
3 = Type 3 embedded barcodes have 6 item codes
without a price check sum and a 4 digit price field.
4 = Type 4 embedded barcodes have 5 item codes
without a price check sum and a 5 digit price field.
7 = Choose 7 if you are embedding a weight, rather
than a price. Use weight when different items are sold
in bulk, such as nut/bolts in a hardware store. When a
weight embedded bar code is scanned the weight is
displayed and must be extended by a price at the cash
register.
CLERK INTERRUPT Y or N
PRG DESC BY CODE Y or N When N, program descriptors by pressing the
appropriate key on the program overlay. When Y,
program descriptors by typing the code for each
descriptor character.
AUTO CUTTER Y or N NOT USED.
USE SPOOL Y or N Choose Y if the paper take-up spool is being used
(single printer models only.)
MCR CLERK SIGN ON Y or N Choose Y to activate the optional card reader for clerk
operations.