INSTALLING THE INTERMEDIATE SHAFT BEARING - (TRANSMISSIONS WITH MINI-REDUCTION ONLY)
The intermediate shaft bearing for
Silver 100.4 -100.6
must be installed without a retaining circlip (see figure 33).
(If this bearing is purchased as a replacement part, it will be supplied with the circlip installed in the groove; this circlip
must be removed prior to installation on the aforementioned models).
Fig. 33 - Assembly of the intermediate shaft bearing.
Fig. 30 - Nominal dimensions of layshaft
bush 2.1559.239.0 (all transmission ver-
sions).
Fig. 31 - Nominal dimensions of layshaft
bush 2.1559.333.0 (all transmission ver-
sions).
Fig 32 - Nominal dimensions of layshaft
bush 2.1552.316.0 (all transmission ver-
sions with Agroshift).
transmission
primary shaft - secondary shaft - reduction gear unit
3
32-33-34
152
www.maskinisten.net
www.classicmachinery.net
To Next Page
Loading...