SETTING THE ANGLE OF THE SBA SENSOR POSITIONING PLATE
Apply Loctite 601 around the periphery of the mounting surface afforded by plate E (Fig 3); proceed to seat the plate,
positioning it so as to obtain an angle of 90°
±
2° between the longitudinal axis of the axle and the flat surface of the
pin.
WARNING: to ensure correct assembly, position the rubber coupling A on the plate after fitting the yoke B and before
fitting the pivot C (see Fig 2).
FITTING THE STEERING ANGLE SENSOR
When positioning the sensor D, make certain that the flat surface of the pin is faultlessly aligned with the outline of the
hole in coupling A (see Fig 2), then tighten the sensor fixing screws.
NB: There is no need to position the sensor in relation to the slots; during the subsequent setup procedure, the All
Round Tester will identify the initial position and assign a value corresponding to a steering angle of 0°.
Fig. 2 - Fitting the steering angle sensor potentiometer.
drive axles - axles
4-W.D. front axle
43
4
208
www.maskinisten.net
www.classicmachinery.net
To Next Page
Loading...