Setting up the Performance Monitor
For the Performance Monitor to operate correctly, a number of parameters must first be entered so that the system
can be tailored to suit the configuration of the tractor on which it is installed.
These parameters are accessed by turning the ignition key while pressing and holding the INFO/PAR key positioned
at the top right of the panel.
The following menu will appear:
The [
↓
] key (6, fig 1) is used to move from one line to the next; the [
←
] key (8, fig 1) is used to access the menu
selected.
Pressing "INFO/PAR" (9, fig 1) returns the system to on-board computer mode.
Entering the type of engine.
Select "PARAMETERS" from the parameters menu, then select "Engine make" with the [
↓
] key (6, fig 1) and press
[
←
] (8, fig 1).
A video page with the engine parameter will appear. Proceed to enter the correct parameter, using [
→
] (5, fig. 1) to
move from one digit to another and [ + ] (7, fig. 1) to increase the value of the selected digit.
Having entered the correct value, press "INFO/PAR" (9, fig. 1) to return to the previous menu.
Enter one of the two values listed in the table, according to the type of engine (air-cooled or water-cooled) fitted to the
tractor.
Entering the tyre size
Select "PARAMETERS" from the parameters menu.
Select "Engine make" with the [ ↓ ] key (6, fig 1) and press [ ← ] (8, fig 1).
A new video page will appear showing the value of the wheels parameter.
Proceed to enter the correct parameter, using [ → ] (5, fig 1) to move from one digit to another and [ + ] (7, fig 1) to
increase the value of the selected digit.
Having entered the correct value, press [ ← ] (8, fig 1) to save, then "INFO/PAR" (9 fig. 1) to return to the previous
menu.
PARAMETERS MENU
LANGUAGE
PARAMETERS
PTO CONSTANTS
CONTRAST
INFORMATION
[
↓
] : [
←
] INFO
AIR cooled engines WATER cooled engines
155 ( ØØ1551) 129 (ØØ129)
body
performance monitor
71
7
338
www.maskinisten.net
www.classicmachinery.net
To Next Page
Loading...
