SAME SILVER 100.4 - Tightening Torques

GEAR CONTROL LINKAGE SLEEVES AND BALL JOINTS TO BE LUBRICATED ON ASSEMBLY
Before assembly, fill the chambers A, with MOLIKOTE grease.
Grease the ball joints B, with MOLIKOTE grease.
Fit bush C, applying LOCTITE 601 to surface indicated in the figure.
Fig. 45 - Sleeve, ball joints
Tightening torques
before tightening all screws should be cleaned and lubricated with engine oil.
kgm Nm
bolts securing front housing to transmission housing 8,6 85
bolts securing intermediate and transmission housings 14 140
bolts securing H-M-L cover 3 30
bolts securing engine to transmission housing 14 140
bolts securing lift housing to transmission housing 8,6 86
crownwheel bolts 12,5 125
bevel pinion lock nut 44 ÷ 48 440 ÷ 480
bolts securing differential flanges 3,3 ÷ 4,1 32 ÷ 40
bolts securing differential cage to halfshaft 13,5 ÷16,8 130 ÷ 164
- Silver 80 - 90 - 100.4 17,5 170
- Silver 100.6 6 60
rear bracket fixing bolts
- Silver 80 - 90 - 100.4 8,6 ÷ 9,6 84 ÷ 94
- Silver 100.6 17 170
rear bracket fixing bolts - Silver 100.6 12 120
P.T.O. shaft lock nut 16 ÷18 160 ÷ 180
bolts securing transmission to engine flange 9 ÷ 11 88 ÷ 107
3
32-33-34
transmission
primary shaft - secondary shaft - reduction gear unit
159
www.maskinisten.net
www.classicmachinery.net