Directions for fitment of windscreen and bulkhead glass
Preparation of surfaces
Clean the edge of the glass thoroughly, in particular the part along which adhesive is to be applied, using a cloth
moistened with GURIT-ESSEX VP 4604 degreaser.
Clean the painted surface of the cab body with which the adhesive will make contact, using CHLOROETHENE or
HEPTANE.
Apply GURIT-ESSEX PRIMER 5001 evenly to the degreased surface of the glass, and allow to dry for at least 10
minutes.
Apply GURIT-ESSEX PRIMER 5002 evenly to the cleaned paintwork, and allow to dry for at least 10 minutes.
Applying the adhesive
Cut the triangular applicator nozzle to an isosceles shape measuring approximately 10 mm across the base and 15
mm high.
Apply the adhesive, GURIT-ESSEX BETASEAL, to the primed surface of the glass.
Squeeze out the adhesive applying uniform pressure and with the gun held in a vertical position.
Position the glass in its seating within 5 minutes, applying pressure uniformly around the periphery until the edge
locates against the spacer lugs.
Sealant
With the windscreen and the two bulkhead glasses in place, two corresponding gaps remain on either side of the
bulkhead. Cover each gap from the inside of the cab with a length of masking tape.
Fill the gaps from the outside with a silicon sealant such as BOSTIK SL 503 (BOSTON).
Thereafter, remove the masking tape.
Seal
Fit the trim seal X as indicated in the diagram attached.
body
driving position
71
7
344
www.maskinisten.net
www.classicmachinery.net
To Next Page
Loading...