SILVER 80-90-100.4-100.6 2
nd
version
(see serial number to page 133).
IMPORTANT: If there is no SBA system installed, and no RADAR device fitted to the tractor, this parameter must be
set to zero.
AUTO-MAN procedure for entering the wheel constant relative to a tyre not listed in the table
1 - Connect the ALL ROUND TESTER to the diagnostics socket of the tractor, which is exposed by lifting the flap on
the right hand side of the instrument panel.
2 - Turn the ignition key to supply power to the control unit, select option "2" [Lift P.], then press any key to return to
the main menu, and press "2" again to select SETTINGS. With the relative video page displayed, press "3" followed
by "C" for change status, and the SETTINGS page will be switched to "AUTO" mode.
3 - Press "E" to exit and return to the “SETTINGS” page with "AUTO" mode activated.
4 - Start the engine, take the lift arms up to maximum height and press the position lock switch (with the padlock
symbol).
5 - Select any gear that will allow the tractor to run at a ground speed above 10 km/h for longer than 30 seconds; this
is the time required by the control unit to compute the new value, which will then be displayed alongside the "WHEELS"
caption.
6 - Having stopped the tractor, press "3" then "C" on the keyboard of the ALL ROUND TESTER, and the "SETTINGS"
page will be returned to MANUAL mode.
IMPORTANT: remember to carry out this last operation, otherwise the tester will not be enabled for the entry of
parameters.
Setting the maximum lift height
To offset any possible misalignment in the mounting of the position control sensor (3, fig 3, page 246), a setting is
made using the maximum lift height as a reference value.
The setting procedure is as follows:
– Connect the All Round Tester to the control unit
– Using the external controls mounted to the fender, raise the lift arms to their maximum height (notch on right hand
lift arm aligned with notch on lift housing, see fig 10).
– Select option 3 (max position setting) from the "Lift P" video page;
– Having accessed the " max position setting" menu, press "E";
– This accesses the "confirm data" menu; press "C" to confirm.
80-90-100.4 HP 100.6 HP
Pneus Version 40 Km/h
(or 30 km/h with
electronic limitation)
Version 30
Km/h
Pneus Version 40 Km/h
(or 30 km/h with
electronic limitation)
Version 30
Km/h
16.9 x 34 4639 6096 14.9 R 38 4527 5971
16.9 R 34 4639 6096 480 / 70 R 34 4648 6170
18.4 R 30 4800 6308 520 / 70 R 34 4498 5931
18.4 R 34 4488 5898 16.9 R 38 4356 5745
13.6 R 38 4670 6138 480 / 70 R 38 4356 5745
480 / 70 R 34 4639 6096
14.9 R 38 4518 5938
520 / 70 R 34 4488 5898
59
5
vehicle
electronic power-lift
243
www.maskinisten.net
www.classicmachinery.net
To Next Page
Loading...