Samoa NEXU - Ucount

NexU
INSTALLATION MANUAL
3.2.4 UCOUNT
As per the UValve, there are two terminals (IN and OUT) for the CANBUS
For connecting the UCount with
you need to use the A B COM SV OUT1 terminals
Connect the COM terminal
electronic
board. Connect
the UCount.
If the pulser has a double reed switch
terminal of the p
ulser to terminal
The device has 3
screen display modes, named “standby mode,
mode.
INSTALLATION MANUAL
As per the UValve, there are two terminals (IN and OUT) for the CANBUS
For connecting the UCount with
external flow control unit (24VDC solenoid valve and pulser)
you need to use the A B COM SV OUT1 terminals
Connect the COM terminal
of the pulse meter to the COM terminal (5) of the U
board. Connect
the pulse generator terminal of the pul
ser to terminal “A” (9
If the pulser has a double reed switch
connect
the other pulse generator
ulser to terminal
“B” (7) of UCount electronic board.
screen display modes, named “standby mode,
“standard” mode and “XXL”
Rev 3 (XXXX 2019)
17
As per the UValve, there are two terminals (IN and OUT) for the CANBUS
external flow control unit (24VDC solenoid valve and pulser)
,
of the pulse meter to the COM terminal (5) of the U
Count
ser to terminal “A” (9
) of
the other pulse generator
“standard” mode and “XXL”