Rev 3 (XXXX 2019)
NexU INSTALLATION MANUAL
70
see that we need to fill in a little more). During this time, the display integrated in the
device will show “top”, giving the possibility to extend the transaction.
Remote Display 1: Selection of a remote display (UView) to show the volume that is
being dispensed.
Remote Display 2: Selection of a second remote display (UView) to show the volume
that is being dispensed.
K Factor: You can change the calibration factor if it already known. In any case, it is
automatically changed when the calibration procedure is made in the UDat.
6.2.2.5 UMETER / UMETER+
Description: You can make a brief description of the UMeter (i.e.: Quick Service
UMeter)
Associated Tank: You have to associate the tank that is physically connected to the
device. When you choose the tank you will see the mane of the tank and the name of
the product inside the tank; i.e. LEFT-HAND TANK (15W40)
Display Quantity: Activates or deactivates the showing of the transaction on the display
integrated on the device. If this option is not chosen, moving arrows are showed on
the display during the transaction.
Pulsemeter Value: This parameter corresponds to the nominal value of the Pulse
meter. The UMeter incorporates a pulse generator of 328 Pulses per minute (PPL).
SV Aperture Delay: Regulates the time the solenoid valve takes to open after the
transaction confirmation.
Suspension Time: Regulates the pause time without receiving pulses from the pulse
generator. If the transaction is interrupted for a time longer than this value, the
transaction is counted as finished and the solenoid valve closes automatically.
Top Up Time: Regulates the waiting time after the initial transaction is completed,
making it possible to do an additional topping in the same transaction although the
preset quantity is achieved. After this stated time it is not possible to dispense an
additional quantity to the transaction and it is considered as completed.
For example, we have ordered 4 litres and after that these 4 litres have been
dispensed, this is the time available for making an additional topping to the original
transaction (for example another 0.2 litres, because even if we initially thought that the
crank case had 4 litres, when the 4 litres are dispensed and the dip stick is checked we
To Next Page
Loading...
