Rev 3 (XXXX 2019)
NexU INSTALLATION MANUAL
85
7.2.3 UVISION+
This screen shows a complete situation of the connected UVision+. Also in this window
you can change some of the parameters.
First column: There is a little picture of the device.
Second column: The address is shown. It represents the number of the local
parameter.
Third column: It shows the description of the device. This description is the one that
was set in the configuration menu.
Fourth column: It shows the dispense mode for the UVision+ (you can choose between
NORMAL and PRESET)
Fifth column: It shows the update botton.
To Next Page
Loading...
