56
Choose the running speed of cooling fans from the following options.
Normal...... Operate in this mode under normal conditions.
Max ........... Use this mode when you want to increase the cooling
effect when operating the projector in high ambient
temperature environment. Fan noise is louder than
Normal.
Setting
Simple mode buttons
Only these buttons are active
when the simple mode is
set to On. [ON, STAND-BY,
INPUT, AUTO PC, INFO.,
MENU, SCREEN, SHUTTER,
ŸźŻŹ6(/(&792/
VOL.-, MUTE, RESET/ON/
ALL-OFF switch] Number
buttons (p.14) also become
active only when setting the
remote control codes numbers
or entering the PIN code
numbers (pp. 54, 60).
Filter control
This function decides whether to activate the simple mode.
Off .... Simple mode function is off.
On .... Only the simple mode buttons are active.
<RXFDQUHSODFHWKH¿OWHUZLWKWKLVIXQFWLRQ3UHVVWKH6(/(&7
button at Filter controlWRGLVSOD\DFRQ¿UPDWLRQER[7RUHSODFH
SUHVVWKH6(/(&7EXWWRQDW³<(6´DQGWKHHOHFWULFDOO\RSHUDWHG¿OWHU
starts to scroll.
3
Note:
• Filter replacement icon and Please wait... message appear on the screen
ZKHQWKH¿OWHULVEHLQJVFUROOHG
7KH¿OWHUFDQQRWEHUHZRXQG
:KHQWKH¿OWHULVUHSODFHGWKHWRWDODFFXPXODWHGWLPHRIWKH¿OWHUXVHLV
automatically set to
0.
A confirmation box appears and
then select Yes.
Back
The eight different remote control codes (Code 1-Code 8) are
assigned to the projector; the factory-set, initial code (Code 1) and
the other seven codes (Code 2 to Code 8).
The same code should be set on both the projector and the remote
control. For example, operating the projector in Code 7, the remote
control code also must be switched to Code 7.
To change the code for the projector
Select a remote control code in this Setting Menu.
To change the code for the remote control:
Press and hold the MENU button and a number button (1-8) on
the remote control for more than five seconds to switch between
the codes. See “Remote Control Code” on page 16.
3Note:
• When different codes are set on the projector and on the remote
control, any operation cannot be made. In that case, switch the code on
the remote control to fit the code on the projector.
• If the batteries are removed from the remote control for a long period of
time, the remote control code will be reset.
Filter control
Fan control
Simple mode
Remote control
3Note:
Warning icon and Simple mode : On message appear on the screen
when press the button which is not the simple mode button.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
