Back to top 5 Installation of Options
S84NX/S86NX Service Manual
117
3
Remove two screws and remove the W-LAN PCB (
3
).
NOTE
• The W-LAN PCB is connected to the CONT PCB with the B to B connector.
Screws
B to B Connector
3
4
Disconnect the coaxial cable (
4
).
4
NOTE
•
Use tweezers, etc. to vertically connect or disconnect
Use tweezers, etc. to vertically connect or disconnect
the coaxial cable connector.
the coaxial cable connector.
•
Applying force to one side of the connector only will
Applying force to one side of the connector only will
damage the connector.
To Next Page
Loading...