Back to top 2 Operation and Confi guration
S84NX/S86NX Service Manual
26
PREND Type 3/4
Set the output content of the external signal PREND
(Print Done).
Refl ect the timing of write (stop media feed) of RFID
tag to the TYPE3 and
TYPE4 waveforms of PREND (Print End) signal.
The options are as follows:
• Normal: Use the usual PREND signal.
• Motion: Refl ect the timing of write (stop media
feed) of tag to the PREND signal.
For the waveforms during the settings of Normal and Motion, refer to the timing chart below.
The timing chart when writing to tag
Item Output Waveform
Normal
Setting
Print end
(PREND)
Print Done
Print motion
TYPE 1
TYPE 2
TYPE 3
TYPE 4
Print start Write
Feed media
Stop feed Feed media
Motion
Setting
Print end
(PREND)
Print Done
Print motion
TYPE 1
TYPE 2
TYPE 3
TYPE 4
Print start Write
Feed media
Stop feed Feed media
To Next Page
Loading...