SATO S84NX - Page 67

Back to top 4 Replacement
S84NX/S86NX Service Manual
65
C
KB cable
I
Stepping motor cable
• Make sure that the stepping motor cable runs through the clamp.
• Make sure that the two ferrite cores (
3
and
4
) are attached with reference to the cable tie
position, respectively.
• Make sure that the stepping motor cable and KB cable are fixed with the Omega lock (a).
• Make sure that the stepping motor cable is fixed to the saddle-2 with the cable tie (b).

LH type
CLAMP
3
4
Cable tie
20 mm
b
Saddle-2
a
Cable tie

RH type
3
4
Cable tie
20 mm
b
Saddle-2
a