SATO S84NX - Page 68

Back to top 4 Replacement
S84NX/S86NX Service Manual
66
J
Head cable
• Make sure that the head cable is fi xed with the ferrite core (
6
).
*S86NX only
• Make sure that the head cable runs through the clamp.
*RH type only
• Make sure that the head cable runs through the saddle.
• Make sure that the head cable is fixed with the ferrite core (
7
).

LH type
6
7
Saddle
• Make sure that the saddle is located near the cable tie of the head cable.
O K N G
Saddle
Cable tie
Cable tie
Saddle

RH type
Saddle
7
CLAMP