SATO S84NX - Page 84

Back to top 4 Replacement
S84NX/S86NX Service Manual
82
5
Remove three screws (S15) attached to the ribbon supply plate assy (
3
).
6
Remove the bearing (
4
) and ribbon supply plate assy (
3
).
S15
S15
S15
4
3
7
Remove the BF stopper (
5
) from the shaft.
5
8
Replace the BF spring (
6
) of the BF stopper
(
5
).
Place the new BF spring (
6
) onto the BF stopper
(
5
). The lower straight end of the BF spring (
6
)
is on the left side of the projection (RED dotted line)
as shown. Then pull the top straight end and hook
onto the right side of the projection.
6
5