Schaerer 7300 - Head Section Operation and Installation; Table Top Section Installation

SECTION I
GENERAL INFORMATION
Page 1-9Printed in U.S.A.
1.6 Special Tools
Table 1-2 lists all of the special tools needed to repair
the unit, how to obtain the special tools, and the pur-
pose of each special tool.
Table 1-2 is on the following page.
Table 1-2. Special Tools List
Description of Special Tool
Manufacturer's
Name / Address / Phone
Manufacturer's
Part Number
Purpose of Special Tool
Multimeter Commercially Available Any Type Used to perform continuity and voltage checks.
Pin Extractor (has
interchangable bits - M3x0.5,
M4x0.7, M5x0.8, M6x1.0,
1/4-20, 10-24, and 5/16-18)
Schaerer Mayfield USA
4900 Charlemar
Drive Cincinnati, Ohio 45227
(800) 755-6381
M05390 Used to pull pins which secure cylinders, handles,
etc. in place. Can also be used to remove caster
fork.
Spanner Wrench - locking nut Schaerer Mayfield USA
4900 Charlemar
Drive Cincinnati, Ohio 45227
(800) 755-6381
M07235 Used to remove locking nut which secures top of
column cylinder in column.
Spanner Wrench - brass pivot
puck
Schaerer Mayfield USA
4900 Charlemar
Drive Cincinnati, Ohio 45227
(800) 755-6381
M07236 Used to remove brass pivot puck which secures
top of column cylinder in column.
Retaining Bolt Schaerer Mayfield USA
4900 Charlemar
Drive Cincinnati, Ohio 45227
(800) 755-6381
M07407 Used to hold rod of column cylinder stationary,
while special tools, M07235 and M07236 are
used.
Spanner Wrench - retainer cap Schaerer Mayfield USA
4900 Charlemar
Drive Cincinnati, Ohio 45227
(800) 755-6381
M07161 Used to remove retainer cap which secures
latching mechansim in place.
Pressure Relief Valve Test
Harness
Schaerer Mayfield USA
4900 Charlemar
Drive Cincinnati, Ohio 45227
(800) 755-6381
M07443 Used to adjust crack settings of motor pump
pressure relief valves and outrigger pressure relief
valve.
Blanking Plug Kit Schaerer Mayfield USA
4900 Charlemar
Drive Cincinnati, Ohio 45227
(800) 755-6381
502-0176-00 Used to cap the end of hydraulic lines to allow
pressure checks to be made.
Soldering Iron Commercially Available Any Type Used to connect wires to terminals with solder.
60 / 40 Solder Commercially Available Any Type Type of solder which should be used when
soldering wires on surgery table.
Internal retaining ring pliers Commercially Available Any Type Used to remove snap rings which secure bearings
in base of cylinders.
Torque Wrench Commercially Available Any Type Used to tighten hardware to specified torque
values.
Transport Tool Schaerer Mayfield USA
4900 Charlemar
Drive Cincinnati, Ohio 45227
(800) 755-6381
502-0169-00 A dolly type tool which is used to transport Model
7100 or 7300 surgical tables around.
Tipping Tool Schaerer Mayfield USA
4900 Charlemar
Drive Cincinnati, Ohio 45227
(800) 755-6381
502-0168-00 Used to tip over Model 7100 or 7300 surgical
tables to access base of table for servicing.
© Schaerer Mayfield USA, Inc. 2004