Schaerer 7300 - Lateral Tilt Position Sensor Removal; Installation

SECTION IV
MAINTENANCE / SERVICE
4.15 Lateral Tilt Position Sensor
Removal / Installation
A. Removal
(1) Remove four plugs (1, Figure 4-20), four screws
(2), and back section table top (3) from R.H. and
L.H. side weldments (4).
(2) Bend lip of two cover gaskets (5) and remove
four screws (6).
(3) Remove bridge cover (7) and two cover gaskets
(5) from R.H. and L.H. side weld- ments (4).
(4) Using emergency override panel, run lateral tilt
function until back section of table top is within
±3° of level from side-to-side. See Figure 4-21.
(5) Tag and disconnect three wires (1, Figure 4-21)
from terminals of lateral tilt position sen-
sor (2).
NOTE
If necessary, cut cable ties and move hoses out of
way.
(6) Remove two screws (3), lateral tilt position
sensor (2), and spacer (4) from rear cross
member (5).
B. Installation
(1) Using terminals of lateral tilt position sensor (2,
Figure 4-21) as a reference point, rotate inner
wheel in clockwise and counterclockwise
direction as far as it will go and then determine
the center point if the inner wheel's rotation.
Page 4-20Printed in U.S.A.
Figure 4-20. Covers Removal / Installation
Figure 4-21. Lateral Position
Sensor Removal / Installation
CA807400
2
4
5
TERMINALS
INNER
WHEEL
EDGE OF
WHEEL WHICH
IS CENTER POINT
FACES TOWARD
TERMINALS
3
1
( +/- 3°)
CA807200
3
1
2
4
5
6
7
4
© Schaerer Mayfield USA, Inc. 2004