Schaerer 7300 - Batteries Removal; Installation

SECTION IV
MAINTENANCE / SERVICE
Page 4-64Printed in U.S.A.
4.39 Batteries Removal / Installation
A. Removal
DANGER
Table is very heavy. Use an assistant
to lay table onto its side. Failure to do
so could result in serious personal injury.
(1) Lay table onto its left side.
(2) Remove five screws (1, Figure 4-68) and battery
cover (2) from base weldment (3).
(3) Pull on both ends of pull strap (4) until terminals
of four batteries (5) can be accessed.
(4) Tag and disconnect eight wires (6) from termi-
nals of four batteries (5).
(5) Remove four batteries (5) from base weld-
ment (3).
B. Installation
(1) Position pull strap (4, Figure 4-68) in base
weldment (3).
(2) Install four batteries (5) in base weldment (3).
Do not push batteries all the way in base
weldment so terminals are not accessible.
(3) Connect eight wires (6) to terminals of four
batteries (5).
(4) Push four batteries (5) into base weldment (3)
fully.
(5) Install battery cover (2) on base weldment (3)
and secure with five screws (1).
(6) Raise table to its upright position.
Figure 4-68. Batteries Removal / Installation
HA5508-00
5
1
2
3
6
6
4
© Schaerer Mayfield USA, Inc. 2004