Schaerer 7300 - Lateral Tilt Cylinder Removal; Installation

SECTION IV
MAINTENANCE / SERVICE
(7) Using a knife with a sharp point, pry orifice (4)
from male connector (3).
(8) Remove male connector (3) from lateral tilt
cylinder (5).
(9) Remove fitting connector (6), fitting seal (7),
and disconnect hose (8) from lateral tilt
cylinder (5).
(10) Remove two locknuts (9) and washers (10 and
11) from two mounting studs (12).
(11) While supporting table top, remove lateral tilt
cylinder (5) from mounting studs (12).
(12) Remove brass spacer (13) from mounting
stud (12).
Page 4-15Printed in U.S.A.
Figure 4-14. Covers Removal / Installation
4.12 Lateral Tilt Cylinder
Removal / Installation
A. Removal
(1) Remove four plugs (1, Figure 4-14), four screws
(2), and back section table top (3) from R.H. and
L.H. side weldments (4).
(2) Bend lip of two cover gaskets (5) and remove
four screws (6).
(3) Remove bridge cover (7) and two cover gaskets
(5) from R.H. and L.H. side weldments (4).
(4) Remove upper front bridge cover (8) by pulling it
out of two snap receptacles (9).
(5) Cover distribution board (1, Figure 4-15) with rag
to protect it from oil.
(6) Tag and disconnect hose (2) from male connec-
tor (3).
Figure 4-15. Lateral Tilt Cylinder
Removal / Installation
CA7632
2
4
5
6
8
9
1
RAG
10
11
13
12
12
3
7
CA807500
POST
3
1
2
4
5
6
8
4
9
7
© Schaerer Mayfield USA, Inc. 2004