Schaerer 7300 - Seat Cylinder Removal; Installation

SECTION IV
MAINTENANCE / SERVICE
(2) Rotate the edge of the inner wheel which
represents the center point of the inner wheel,
so it is facing terminals of lateral tilt position
sensor (2).
(3) Install spacer (4) and lateral tilt position sensor
(2) on rear cross member (5) and secure with
two screws (3), making sure center point does
not get changed.
(4) Connect three wires (1) to terminals of lateral tilt
position sensor (2).
(5) Install any cable ties which were removed.
(6) Perform calibration of return to level / neutral
position procedure (Refer to para 4.3).
(7) Install two cover gaskets (5, Figure 4-20) and
bridge cover (7) on R.H. and L.H. side
weldments (4); then bend lip of cover gaskets
back and install four screws (6).
(8) Install back section table top (3) on R.H. and
L.H. side weldments (4) and secure with four
screws (2).
(9) Install four plugs (1) on back section table
top (3).
4.16 Seat Cylinder Removal / Installation
A. Removal
(1) If installed, remove Pelvic Base or any other
section from pins of pivot blocks on foot end.
(2) Remove four plugs (1, Figure 4-22), four screws
(2), and back section table top (3) from R.H. and
L.H. side weldments (4).
(3) Carefully bend up lip of two cover gaskets (5)
and remove four screws (6).
(4) Remove bridge cover (7) and two cover gaskets
(5) from R.H. and L.H. side weldments (4).
(5) Remove upper front bridge cover (8) by pulling it
out of two snap receptacles (9).
NOTE
It will be necessary to swing lateral tilt cylinder out of
the way in order to use pin extractor to remove
connecting pin.
Page 4-21Printed in U.S.A.
Figure 4-22. Covers Removal / Installation
CA807500
POST
3
1
2
4
5
6
8
4
9
7
© Schaerer Mayfield USA, Inc. 2004