SECTION IV
MAINTENANCE / SERVICE
4.33 Emergency Override Panel
Removal / Installation
A. Removal
(1) Raise cover (1, Figure 4-60) up out of way.
NOTE
One of the spring retainers must be depressed in
order to remove Emergency Override Panel.
(2) Insert a small allen wrench or equivalent in one
of the access holes (2) on side of mounting
panel weldment (3).
(3) Insert a thin, straight blade screwdriver, on the
same side as the allen wrench, in the notched
out section (4) on the switch plate assembly (5).
CAUTION
Pull switch plate mounting panel
out carefully. Pulling quickly could
damage emergency override board or connector.
(4) While pushing in on the allen wrench to depress
the spring retainer, carefully pry upward on the
switch plate assembly (5).
(5) Disconnect wire harness (6) from emergency
override board (7).
NOTE
Place the switch plate assembly face down to
prevent the switch actutor plates from falling out
when removing the emergency override board.
(6) Place switch plate assembly (5) face down and
remove eight mounting screws (8), then remove
emergency override board (7).
B. Installation
NOTE
Assure all switch actuator plates are in place before
installing emergency override board.
(1) Install emergency override board (7) on switch
and secure with eight screws (8).
(2) Connect wire harness
(3) Carefully install switch plate assembly (5) onto
table, pressing down on switch plate assembly
until it snaps securely in place.
(4) Lower cover (1) down to closed position.
Page 4-57Printed in U.S.A.
Figure 4-60. Emergency Override Board
Removal / Installation
© Schaerer Mayfield USA, Inc. 2004
To Next Page
Loading...