Schaerer 7300 - Page 90

SECTION IV
MAINTENANCE / SERVICE
(2) Install charging / power driver board (5) in
electrical box (2) and secure with two
lockwashers (9), screws (8), and two
screws (7).
(3) Connect six wires (6) to charging / power driver
board (5).
(4) Connect three wire harnesses (4) to charging /
power driver board (5).
(5) Install electrical box (2) on base weldment (3)
and secure with two or four screws (1).
(6) Install box cover (12, Figure 4-58) on electrical
box (13) and secure by tightening four captive
screws (11).
(7) Install cover (10) on base weldment (3) and
secure with two screws (9).
(8) Install caster (7) on caster fork (8) and secure
by tightening two locknuts (6).
(9) Connect four hot wires (4) to terminals of
batteries (5).
(10) Install battery cover (2) on base weldment (3)
and secure with five screws (1).
(11) Raise table to its upright position.
Page 4-56Printed in U.S.A.
Figure 4-59. Charging / Power Driver Board
Removal / Installation
HA5503-00
1
2
3
4
6
7
8
9
5
© Schaerer Mayfield USA, Inc. 2004