SECTION IV
MAINTENANCE / SERVICE
(5) Remove solenoid gasket (14) from valve
manifold block (8).
(6) Loosen screw (15) and disconnect connector
plug (16) from solenoid (12).
(7) Remove plug gasket (17) from solenoid (12).
B. Installation
(1) Install plug gasket (17) on solenoid (12).
(2) Connect connector plug (16) to solenoid (12)
and secure by tightening screw (15).
(3) Install solenoid gasket (14) on valve manifold
block (8).
(4) Coat o-ring (11) with a very light coat of oil.
(5) Install solenoid (12) on solenoid mounting shaft
(13) and secure with o-ring (11), cap (10), and
nut (9).
(6) Install manifold assembly (8) in base weldment
(3) and secure with two spacers (7), mounting
bracket (6), two screws (5), and two screws (4).
(7) Install main cover (2) on base weldment (3) and
secure with six screws (1).
(8) Raise table to an upright position.
Page 4-38Printed in U.S.A.
© Schaerer Mayfield USA, Inc. 2004
To Next Page
Loading...
