SECTION IV
MAINTENANCE / SERVICE
Page 4-46Printed in U.S.A.
(7) Install pump unit (8) on manifold (5) and secure
with two lockwashers (7) and screws (6),
making sure shaft of pump unit is mated with
coupler (12).
(8) Coat gasket (4) with oil.
(9) Install gasket (4) on pump cover (1).
(10) Install pump cover (1) on manifold (5) and
secure with four lockwashers (3) and screws (2).
(11) Install shipping plug in pump cover (1).
(12) Perform steps 11 thru 25 of para 4.26 B,
Installation.
(13) Dispose of used oil in accordance with local
regulations.
Figure 4-47. Pump Unit Removal / Installation
© Schaerer Mayfield USA, Inc. 2004
To Next Page
Loading...
