HB-37350-810-01-50F-EN PSC1-C-10 Installation manual V2.1.docx Page 13 of 189
Version: 50F
3.3 General safety instructions
Safety instructions:
To prevent injury and damage, only qualified personnel are allowed to work on the
device. Qualified personnel are personnel who have electrical engineering training and
who are familiar with the applicable rules and standards of electrical engineering.
The qualified person must become familiar with the operating instructions
(cf. IEC364, DIN VDE0100).
The qualified person must have, as a minimum, detailed knowledge of national health
and safety regulations
The usage of the devices is to be limited to their intended usage as per the list given
above. The values in the data listed in section "3.2. Device characteristic data" are also
to be met.
The content of these installation instructions is limited to the basic function of the
devices and their installation. The programming of the devices and re-configuration of
the device parameters is further described in the "Programming instructions
SafePLC2". Detailed knowledge and understanding of this information is a vital
prerequisite for a new installation or the modification of the device function or device
parameters.
Commissioning (i.e. commencing operated as intended) is only allowed on compliance
with the EMC directive. The EMC test standards EN55011:2007 + A2:2007 and EN
61000-6-2:2005 are used as the basis.
For storage and transport the conditions according to EN 60068-2-6 in relation to the
values stated in "Tech. characteristic data" are to be met
It is imperative the wiring and connection instructions in the section "Installation" are
followed.
The applicable VDE regulations as well as other special
safety regulations for the specific application are to be followed.
The monitoring functions configured as well as their parameters and operators are to
be validated via a validation report.
The module's implementation is to be agreed with the responsible body (e.g. TÜV or
BG).
Never install or place in operation damaged products. Please report any damage
immediately to the transport company.
Never open the housing and/or make any unauthorised modifications
Inputs and outputs for standard functions and the digital and analogue data transmitted
via communication modules are not allowed to be used for safety-related applications.