schmersal PSC1-C-10 Series User Manual

Installation manual
HB-37350-810-01-50F-EN PSC1-C-10 Installation manual V2.1.docx Page 150 of 189
Version: 50F
9 Maintenance
9.1 Modification / dealing with changes to the device
Servicing work is only allowed to be undertaken by qualified personnel.
It is not necessary to undertake regular servicing work.
Repair
Devices are always to be replaced completely.
It is only possible to repair a device in the factory.
Warranty
The warranty will be rendered void if the module is opened without authorisation.
Note:
The modification of the module will render void the safety approval!
9.2 Replacement of a module
On the replacement of a module the following should be noted:
 Disconnect power converter from the main supply.
 Switch off power supply for the device and disconnect.
 Disconnect encoder connector
 Remove all other plug-in connections.
 Remove module from the DIN rail and correct correctly in relation to EMC.
 Fit new module to the DIN rail.
 Restore all connections.
 Switch on power converter.
 Switch on supply voltage.
 Configure device
Note:
In principle, no plug-in connection on the PSC1 module is allowed to be disconnected or
connected again while electrically live. In particular, there is a risk of irreparable damage to
position or speed sensors connected.
9.3 Servicing interval
Module replacement
See technical data
Function test
See section Commissioning

schmersal PSC1-C-10 Series Specifications

General

Brand	schmersal
Model	PSC1-C-10 Series
Category	Control Unit
Language	English