schmersal PSC1-C-10 Series User Manual

Installation manual
HB-37350-810-01-50F-EN PSC1-C-10 Installation manual V2.1.docx Page 148 of 189
Version: 50F
7.5 Parameter configuration
The parameters are configured using the program SafePLC2. To be able to send the data to
the module, a programming adapter is required; the user must install the driver for this adapter
prior to use.
For a description of the parameter configuration, see Programming manual.
7.6 Function test
To safeguard the safety of the module, a function test on the safety functions must be
undertaken once per year.
7.7 Validation
To safeguard the safety functions implemented, the parameters and operators must be
checked and documented by the user after completion of commissioning and parameter
configuration. Support for this task is provided by the validation wizard in the user interface
(see section "Safety-related check").

schmersal PSC1-C-10 Series Specifications

General

Brand	schmersal
Model	PSC1-C-10 Series
Category	Control Unit
Language	English