HB-37350-810-01-50F-EN PSC1-C-10 Installation manual V2.1.docx Page 14 of 189
Version: 50F
WARNING:
The usage of our devices contrary to the rules and conditions stated here can result in the
injury or the death of persons, as well as damage to the devices and machines connected!
This usage will also render void any claim under the warranty or any claim for claim damages
against the manufacturer.
3.4 Operating and service
Prior to installing and removing the module, or disconnecting the signal wires, the module is to
be electrically isolated. For this purpose all electrically live supply wires to the device are to be
switched off and it is to be checked that there is no electrical power present on the wires.
During the installation and removal of the module, appropriate
measures are to be taken to prevent electrostatic discharges on the external terminals and
connections. Contact with these terminals should therefore remain limited to a minimum; prior
to and during this work you should be earthed, e.g. using an earthing wrist strap.
To Next Page
Loading...
Need help?
General
