Seat NAVI SYSTEM PLUS - WLAN Hotspot

Connectivity
WLAN hotspot
Introduction
3 Only available for the model: Navi System
(with WLAN connection) and Navi System Plus.
The Infotainment System can be used to
share a WLAN connection with up to 8 devi-
ces
›››
page 28, Configuration to share
connection via WLAN.
The Infotainment System can also use the
WLAN hotspot of an external wireless device
to provide Internet to the devices connected
to the hotspot (WLAN client)
›››
page 29,
Configuring internet access.
Note
●
Data transmission may incur charges.
Due to the high volume of data exchanged,
SEAT recommends the use of a flat rate
mobile phone deal for data transmission.
Mobile phone operators can provide the
relevant information.
●
The exchange of data packages over the
internet may generate additional costs, de-
pending on your mobile phone rate, partic-
ularly if you are abroad (for example,
roaming rates).
Configuration to share connection
via WLAN
The Infotainment System can be used to
share a WLAN connection with 8 wireless de-
vices.
Establishing the connection with the wire-
less network (WLAN)
●
Press the Infotainment button  and
then press the Settings menu.
●
Activate the wireless network (WLAN) on the
Infotainment System. To do so, press the
WLAN function button.
●
Activate the wireless network (WLAN) on the
wireless device that is to be connected. If
necessary, refer to the manufacturer’s in-
struction manual.
●
Activate the mobile device assignment on
the Infotainment System. To do so, press the
Enable WLAN connection
button and activate
the checkbox.
●
Enter and confirm the network key dis-
played on the wireless device.
The following settings can also be made on
the menu Share connection:
WPA2 encryption automatical-
ly generates a network key.
Network key automatically gen-
erated. Press the function button to
manually change the network key. The
network key must have a minimum of 8
characters and a maximum of 63.
WLAN Network name (maximum of 32
characters).
Activate
the checkbox to deactivate the visibility
of the wireless (WLAN) network.
The wireless (WLAN) connection is establish-
ed. To complete the connection, it may be
necessary to enter other data into the wire-
less device.
Repeat this process to connect other wireless
devices.
Wi-Fi Protected Setup (WPS)
1)
3
Only available for the model: Navi System
(with WLAN connection)
Wi-Fi Protected Setup can be used to create
a ciphered local wireless network quickly and
simply.
Security level:
Network key:
SSID:
Do not send network name (SSID):
1)
This function depends on the equipment and
the country in question.
28