Seca 654 - 7.4 Setting up network functions; Setting up the device in the seca connect 103 software

Configuration • 115
English
17-10-07-654-100_01-2020B
7.4 Setting up network functions
CAUTION!
Malfunction, implausible measuring results
If network settings are not carried out correctly, measuring results can
be assigned incorrectly or lost.
► Have the steps described in this section carried out by your admin-
istrator or hospital technician. If you have any questions, contact
seca Service.
NOTE
As soon as the device is connected to a network, the Autohold func-
tion is activated automatically. The Autohold function cannot be
deactivated if the device is connected to a network.
The following requirements must be met to be able to assign measured val-
ues to an electronic patient file in an EMR System or the seca analytics 125
software:
• Device is set up in the seca connect 103 software
• Device is connected to your network via a LAN or WiFi connection
• An interface is set up in the seca connect 103 software to your EMR
System or the seca analytics 125 software
• Barcode scanner is connected to the device
On connection to an EMR System, the measurement procedure consists of
the following steps:
• Record ID(s) using barcode scanner
• Record measured values on the device
•Use the
seca connect 103 software to transmit the measuring results
to the EMR System
NOTE
The measurement procedure (workflow settings) can be individually
adapted in the seca connect 103 software.
Setting up the device in the
seca connect 103 software
For data transmission between the device and your EMR System, the device
must be set up in the seca connect 103 software. Amongst others, the fol-
lowing data must be entered:
• Device name
• Setup location
• Workflow settings (measurement procedure)
• Address of the
seca connect 103 server
• Network port
1. Set up the device in the seca connect 103 software as described in the
system instructions for use for the seca connect 103 software.
The software generates a QR code containing the entered information.
2. Make sure that a barcode scanner is connected to the device
➔
Connecting a barcode scanner (optional), page 94.
3. Scan the QR code from the software user interface or a paper printout.
The settings carried out in the seca connect 103 software are stored in
the device.
seca
software