116 • seca 655/654
17-10-07-654-100_01-2020B
4. You have the following options for continuing:
► LAN: Connect the device to the network using a LAN cable
► WiFi: ➔ Connecting the device to the WiFi network
(seca connect 103), page 117
NOTICE!
Malfunction
To be able to transmit measuring results to an EMR System, an inter-
face must be set up between the seca connect 103 software and the
EMR System.
► Observe the system instructions for use for the seca connect 103.
► Set up the interface in cooperation with the manufacturer of your
EMR System.
Entering the IP address
NOTE
Manual entry is only necessary if no barcode scanner is connected to
your device. If a barcode scanner is connected, the network connec-
tion can be set up from the seca connect 103 software.
1. Press the key.
The Settings menu is displayed.
2. Press the or key until the Network menu item is displayed.
3. Press the Network item.
4. Press the Server address item.
5. Enter the IP address of the server on which the
seca connect 103
software is installed:
a) Enter the value
b) Confirm your entry by pressing the key
6. You have the following options for continuing:
► Connect the device to the network using a LAN cable
► Establish a WiFi connection ➔
Connecting the device to the WiFi
network (seca connect 103), page 117
Device mode Function available
Basic –
Advanced –
Expert •
Service •
To Next Page
Loading...
