2.5
Installation instructions for the three arrangements are as follows:
1. Surface mounting using kit 01100 401 (Figure 2.2)
Attach the two straps to the rear of the Control unit using the screws supplied.
This unit can now be hung on any convenient vertical surface.
2. Flush panel mounting using kit 01100 413 (Figure 2.3)
Make a rectangular hole in the panel as shown in Figure 2.3.
Insert the Control unit through the panel from the front.
Fasten in place with the brackets and screws provided,
making sure that the flanges at the front of the control unit are tight against the panel.
Each bracket is fixed to the unit with two screws.
3. 19 inch rack mounting using panel kit 01100 414 (Figure 2.4).
Insert the Control unit through the hole in the panel from the front.
Continue as described in section 2.4.2, para (2) "Flush Panel Mounting".
To Next Page
Loading...
