SEW-Eurodrive DH 41B Series - Installing and Removing the DH.21;41 B Option Card

5
Mechanical installation
In MOVIDRIVE®MDX61B
Manual – DHE/DHF/DHR21B (standard) and DHE/DHF/DHR41B (advanced)
18
5.2.2 Installing and removing the DH.21/41B option card
Proceed as follows:
1.
4.
3.
2.
2102036363
1. Remove the retaining screws holding the card retaining bracket. Pull the card re-
taining bracket out evenly from the slot (do not twist!).
2. Remove the retaining screws of the black cover plate on the card retaining
bracket. Remove the black cover plate.
3. Position the option card onto the retaining bracket so that the retaining screws fit
into the corresponding bores on the card retaining bracket.
4. Insert the option card retaining bracket with the installed option card into the slot,
pressing slightly so it is seated properly. Secure the option card retaining bracket
with the retaining screws.
5. Follow the instructions in reverse order when removing the option card.
22900055/EN – 08/2016