7
Project planning and startup with MOVITOOLS
®
MotionStudio
First steps
Manual – DHE/DHF/DHR21B (standard) and DHE/DHF/DHR41B (advanced)
46
5. If necessary, change the preset communication parameters. When doing so, refer
to the detailed description of the communication channels.
6. Scan your network via the "Device scan" icon[1] in the toolbar.
27021598896943499
7.2.3 Connection mode
Overview
The MOVITOOLS
®
MotionStudio engineering software differentiates between "online"
and "offline" connection mode. You determine the connection mode yourself.
MOVITOOLS
®
MotionStudio starts up in the connection mode that was set before the
program was closed.
INFORMATION
The "Online" connection mode is not a response message which informs you that
you are currently connected to the device or that your device is ready for communica-
tion.
• Should you require this feedback, observe chapter "Setting the cyclical accessibil-
ity test" in the online help (or the manual) of MOVITOOLS
®
MotionStudio.
INFORMATION
Project management commands (such as "download" and "upload"), the online
device status, and the "device scan" work independently of the set connection mode.
22900055/EN – 08/2016
To Next Page
Loading...
