SEW-Eurodrive DH 41B Series - Technical Data of the DHF21 B;41 B Option Card

10
Technical data and dimension drawings
Technical data of the DHF21B/41B option card
Manual – DHE/DHF/DHR21B (standard) and DHE/DHF/DHR41B (advanced)
78
DH.21B/41B
Engineering Engineering of the DHE21B/41B option card is carried out using the
MOVITOOLS
®
MotionStudio engineering software with PLC Editor. The
DHE21B/41B controller is connected with the engineering PC via the:
• "X35: USB engineering interface"(→236)
• "X37: Ethernet 2 engineering interface"(→237)
The engineering of any SEW‑EURODRIVE components connected to the
DHE21B/41B option card can be carried out via the DHE21B/41B option card.
Engineering of the DHE21B/41B option card cannot be carried out via the in-
verters.
10.3 Technical data of the DHF21B/41B option card
INFORMATION
The technical data of the connections that are identical with the DHE21B/41B option
card are described in chapter "Technical data of the DH.21B/41B option
card"(→276).
DHF21B/41B
Part number
• DHF21B: 18236081
• DHF41B: 18211615
Electrical supply
• Installed in MOVIDRIVE
®
MDX61B:
– Power consumption: P
max
= 8 W
• Installed in the MOVIAXIS
®
MXM master module:
– Power consumption: P
max
= 10W
Potential levels
• Potential control/CAN1/COM1
• Potential COM2
• Potential digital inputs and outputs
• Potential system bus CAN2
• Potential PROFIBUS
PROFIBUS connection
(X30P:1–X30P:9)
• Via 9-pin D-sub connector, pin assignment to IEC 61158
• Bus termination not integrated. Activate bus termination with suitable
PROFIBUS connector with switchable terminating resistors.
• Automatic baud rate detection: 9.6kBaud–12MBaud
22900055/EN – 08/2016