SEW-Eurodrive DH 41B Series - Configuring and Starting up Drives; Configuration and Startup in the PLC Editor; Replacing the Unit

7
Project planning and startup with MOVITOOLS
®
MotionStudio
Configuring and starting up drives
Manual – DHE/DHF/DHR21B (standard) and DHE/DHF/DHR41B (advanced)
62
7.7 Configuring and starting up drives
Project planning and startup for drives is described in the following library manuals.
Drive Manual
MOVIDRIVE
®
B
MOVIAXIS
®
Libraries MPLCMotion_MDX and MPLCMotion_MX for
MOVI‑PLC
®
MOVITRAC
®
07 / B
MOVIMOT
®
Libraries MPLCMotion_MDX and MPLCMotion_MM for
MOVI‑PLC
®
INFORMATION
If you want to operate the DH.21B/41B option card installed in MOVIDRIVE
®
MDX61B, then the firmware of the MOVIDRIVE
®
MDX61B inverter must have at least
status".16".
This applies regardless of whether the inverter is controlled via the installed
DH.21B/41B option card or whether the slot of the inverter is only used for installing
the DH.21B/41B option card while it is simultaneously used to control other inverters
(e.g. MOVITRAC
®
B).
7.8 Configuration and startup in the PLC Editor
INFORMATION
• For further information on configuration and startup of the DH.21B/41B option
card, refer to the "MOVI‑PLC
®
programming in the PLC Editor" system manual.
• For information on how to configure the master in the various fieldbus systems,
refer to the following documentation:
– DHF21B/41B Controller Fieldbus Interfaces DeviceNet
TM
and PROFIBUSDP-
V1
– DHR21B/41B Controller Fieldbus Interfaces EtherNet/IP
TM
, Modbus TCP/IP
and PROFINET IO
7.9 Replacing the unit
For replacing a DHF21B/41B option card, a compact controller or a controlled drive,
follow the instructions in chapter "Installing and removing the DH.21/41B option
card"(→218). Insert the SD memory card of the previous controller into the new con-
troller.
INFORMATION
The variable values stored remanently on the DH.21B/41B option card are not stored
on the SD memory card by default. This can be programmed through the application
(IEC program), or the data backup must be imported through the project manage-
ment in MOVITOOLS
®
MotionStudio.
For information on replacing the drives, refer to the manual of the inverter in question.
22900055/EN – 08/2016