SEW-Eurodrive DH 41B Series - Communication via USB

7
Project planning and startup with MOVITOOLS
®
MotionStudio
Communication via USB
Manual – DHE/DHF/DHR21B (standard) and DHE/DHF/DHR41B (advanced)
50
7.3 Communication via USB
7.3.1 Connecting the unit with the PC via USB
The illustration shows how the device (in the example a gateway [3]) is connected with
the PC [1] using a USB connection cable [2]. It also shows how the gateway [3] is con-
nected with the lower-level device [5] via SBus (CAN).
[1]
[5]
[3]
[2]
[4]
1
5
1716605579
[1] PC with USB port
[2] USB connection cable
[3] Gateway (UFx41 in the example)
[4] System bus connection (CAN based) between the gateway and the lower-level
device
[5] Lower-level device (MOVIAXIS
®
in the example)
Proceed as follows:
1. Plug the A connector of the USB cable[2] into a free USB port on your PC[1].
2. Insert the USB-B connector of the USB cable[2] into the USB port on your gate-
way[3].
3. Connect the system bus interface of the gateway[3] with the SBus interface of the
lower-level device[5].
22900055/EN – 08/2016