2. In this mode, the openSPOT4 broadcasts its own Wi-Fi network called
openSPOT4 AP, indicated by white LED. You can connect to this network
using your browser device (phone/tablet/computer).
3. Make sure you place your browser device close to the openSPOT4 during
this time.
4. The initialization setup will pop up, where you can select a Wi-Fi network
for the openSPOT4 to connect to. If the initialization setup won't open
automatically, then you can open it by entering http://192.168.99.1/ into the
web browser while your browser device is connected to the Wi-Fi network
openSPOT4 AP. Note that this address is only active while the
openSPOT4's AP mode is enabled, indicated by white status LED.
5. Exit the initialization setup by clicking on the Exit button.
6. Enable
Advanced mode
at the bottom right of the web interface.
7. Go to the Network page, Wireless settings section.
8. Set your home Wi-Fi as SSID #1 (and key) and your phone's Wi-Fi as SSID
#2 (and key). If your home Wi-Fi (SSID #1) is not reachable then the
openSPOT4 will automatically try to connect to your phone's Wi-Fi (SSID
#2).
Make sure you enter passwords case sensitive.
If you use an iPhone then:
Make sure you use the Save button at the Wireless scan list to save the
iPhone's Wi-Fi network to SSID #2 as it contains a special apostrophe
character which you can't enter using your keyboard
Make sure you keep the iPhone's Wi-Fi hotspot settings page open while
doing a wireless scan on the openSPOT4, because the iPhone only
broadcasts its Wi-Fi network name if that page is kept open on the phone.
We have tested the OS3 with iOS versions up to 13. Newer iOS versions
may work differently.
The openSPOT4 won't turn on
Press and hold the power button for at least 7 seconds
Make sure you've charged the device for at least 30 minutes
Use a different wall charge adapter or different USB port on a computer to
charge the unit
Try flipping the USB-C connector of the cable upside down
I get Connector authentication failed messages
Please take a look at this post.
You need to check the hotspot security setting on your BrandMeister SelfCare
page. If hotspot security is turned on, you have to use the hotspot password
you've set there as the server password in the openSPOT4. If hotspot security is
turned off, then you have to use the default server password which is
"passw0rd" (without the double quotation marks).
To Next Page
Loading...
