SharkRF openSPOT2 - Enabling the GPS Receiver; Advanced Settings

EnablingtheGPSreceiver
GotoDISP>APRS>GPSPOWERandselectON.
EnablingGPSdatasendingduringvoicecalls
GotoDISP>TX/RX>DIGITAL>LOCATIONSERVICEandselectON.
NowyourradiowilltransmitlocationinformationduringyourcallsifithasaGPSfixandyouholdthePTTforat
least2-3seconds.TheopenSPOT2willautomaticallysetanSSIDandsymbolforlocationreportsbasedonthe
transceivertypeinthereceivedlocationdata.
Advancedsettings
IfyouwanttoselectyourownAPRSsymbol,SSIDandcommentforyourtransceiverthenenableAdvanced
mode,gototheConnectorspage,opentheAPRSconnectorsettings,andenableforcedSSID/symbol/comment.
Settingupyourtransceiver
28