SharkRF openSPOT2 - Location Settings

grouplist.
NXDN:voiceannouncementsaresenttoTG0.
IfyouenableAdvancedmode,thefollowingsettingswillshowup:
YoucanshortenprofileannouncementsbycheckingtheShortenedprofileannouncementcheckbox.
Ifyoudon'twanttohearthelinkedreflector/talkgroupslist,thenyoucanshortenBrandMeister
announcementsbycheckingtheShortenedBrandMeisterannouncementcheckbox.
Youcandisablebuilt-invoiceannouncementsbycheckingtheUseserveronlycheckbox.Notethatstartup
voiceannouncementsplayedrightaftertheopenSPOT2bootswillstillbeplayedfromtheopenSPOT2'sflash
memory.
Youcansetyourownvoiceannouncementserver'shostandport.
Netstateannouncementint.setstheintervaloftheannouncementiftheopenSPOT2can'tconnecttoa
Wi-Finetwork.
SeetheControlcallssectionformoreinformationaboutProfilequery/changebaseID,ConnectorqueryIDandIP
addressqueryID.
Locationsettings
Settinglocationdataisoptional.ItisusedbysomeconnectorsliketheHomebrew/MMDVMtoreportthelocation
oftheopenSPOT2totheconnector'snetwork.
Latitudeandlongitudeisindecimaldegrees.GoogleMapswilldisplayalocation'scoordinatesindecimaldegrees
ifyouclickonit:
BothheightvaluesrefertotheheightofyouropenSPOT2(theyareusedseparately).
Settingspage
49